Seam sealing
Panel joints are cleaned and resealed where most leaks begin.
A Kenilworth roofer can fix leaks on metal, rubber and shingle mobile home roofs, working with the light framing these homes are built on. One call to (908) 613-5001 reaches a nearby roofer who works on mobile homes.
Leaks on a manufactured home roof tend to follow a predictable pattern. Many older homes have a low slope metal roof fastened over lightweight trusses, while others have a rubber membrane or, on newer homes, a pitched shingle roof. For metal roofs, panel seams, fastener holes and dried sealant at vents and the perimeter edge cause most leaks.
Small leaks spread fast in a mobile home. The thin materials used in many mobile homes stain, swell and grow mold quickly once they get wet. If a ceiling panel bulges with trapped water, a small hole at the low point lets it drain into a bucket, keeping clear of light fixtures, and power to that area should be shut off at the panel if it is safe to reach.
Climbing on a mobile home roof is riskier than it looks. Weight should go on the trusses, not between them, which is why roofers often use boards to spread their weight. Stay off a wet or icy roof, and look for the data plate inside the home, which shows the roof load the home was designed for.
Many mobile home roof repair calls in Kenilworth also turn up a need for roof coating or metal roof repair.
Dealing with this in Kenilworth, NJ right now? Call (908) 613-5001 to talk to a local roofer.
Call nowHere is how a roofer usually approaches a mobile home roof repair.
The roofer walks the truss lines or works from a ladder, checking seams, fasteners, the perimeter edge and every vent, skylight and curb. Stains on the ceiling inside help narrow down the source.
Missing or loose screws are replaced and panels are secured so the roof stops rumbling. Surface rust is wire brushed and primed.
Panel seams are cleaned and sealed with butyl seam tape or a reinforced seam sealer. On rubber roofs, the roofer patches with matching membrane and lap sealant.
Every roof penetration is resealed, with brittle vent caps or skylight domes replaced. The edge rail around the roof is resealed too.
On metal and some membrane roofs, a full elastomeric or silicone roof coating is applied after repairs to seal small gaps and reflect sun. Coatings need dry weather and a clean surface to bond.
Panel joints are cleaned and resealed where most leaks begin.
Backed out fasteners are swapped to close leaks at every screw.
Soft spots are cut out and rebuilt where water sat the longest.
The roof is recoated after repairs which slows rust on metal.
Vents, skylights and the AC curb are resealed to stop leaks at each opening.
A full mobile home roof replacement is the answer when rust, rot or a worn membrane has spread across the roof. Depending on the home, the new roof may be metal, a single ply membrane such as EPDM or TPO, or shingles on a pitched roof. Damaged trusses are fixed first.
A mobile home roof replacement in Kenilworth starts with the trusses, since the new roof has to stay within what they can carry. A permit may be required, and rules for manufactured homes can differ from site-built homes, so the roofer should check local requirements. The goal is a roof that sheds water and stays quiet in the wind for years.
Rather than removing the old metal, a roof over adds a new roof system above it. The most common types are a pitched roof over with trusses and shingles or metal, a flat roof over with insulation board and a single ply membrane, and a metal roof over on furring strips. Many roof overs add insulation, cutting heat gain and making the home quieter in storms.
Before a roof over on a Kenilworth mobile home, the added load and the way the new roof ties into the walls have to be worked out. A pitched roof over changes the structure, so it often needs a permit and engineering, plus solid anchoring for wind. A good roof over ends the seam and screw leaks that plague old metal roofs.
Around Kenilworth, mobile home roofs include older metal roofs, rubber membrane roofs and newer shingle roofs on pitched manufactured homes. For homes in Kenilworth and nearby towns like Roselle Park, Union, Cranford and Roselle, resealing and recoating every several years keeps most metal roofs dry, and storms with strong wind are what loosen fasteners and lift edges.
Need mobile home roof repair around Kenilworth? Call (908) 613-5001 for a Kenilworth roofer who serves the towns around it too.
Winters here are long and cold, with snow on the roof for weeks at a time and plenty of nights below freezing. When warm attic air melts the snow, the meltwater runs down and freezes again at the eaves, building ice dams that push water up under the shingles. Coastal storms and heavy spring rain drive water sideways into flashing, valleys and old chimneys. That is why roof repair in Kenilworth is busiest after a hard winter and before the next one.
A roof problem fixed early rarely spreads to the decking, the insulation or the ceilings.
Roofers in Kenilworth know the roof types and weather wear common in local homes.
Ask your questions before you agree to anything.
More questions? Call (908) 613-5001
Silicone, acrylic and other liquid coatings that renew aging flat, low-slope and metal roofs, when the roof underneath is still dry and solid.
Learn moreMetal roof repairs that stop leaks at the screws, laps and flashing, matched to exposed fastener and standing seam roofs alike.
Learn moreFixing open seams, punctures, shrinkage and split flashing on EPDM rubber roofs, after the real leak point is found.
Learn moreLeak repairs that fix the entry point, not just the ceiling stain, before wet decking and insulation turn into rot.
Learn moreLooking for something else?
See all roofing servicesCall (908) 613-5001 for a local roofer in Kenilworth and nearby towns.