Ridge ventilation
Vented ridge closures let the attic breathe while keeping out rain and pests.
Metal Roofing
Metal Roof Installation Kenilworth, NJ
A Kenilworth roofer can help you choose between standing seam, ribbed panels and metal shingles and install the full system, so the roof is set up for decades of service. One call to (908) 613-5001 reaches a nearby roofer who installs metal roofs.
The first choice in any metal roof installation is the panel system. Exposed fastener panels, such as corrugated and ribbed panels, are screwed through the face and go on quickly, but every screw has a washer that will need attention someday. Standing seam panels hide their clips under raised seams, so nothing pierces the flat of the panel and the metal can expand and contract freely.
Next comes the metal itself and the paint on it. Steel with a zinc or aluminum-zinc coating is the standard, while aluminum avoids rust in salty air. A fluoropolymer (PVDF) paint finish holds color longer than a silicone modified polyester finish, and 24 or 26 gauge steel is typical for homes.
What goes under the metal is easy to overlook and important to get right. Panels normally go over solid sheathing and a heat-rated underlayment, with an ice barrier in the eaves and valleys. Open purlin framing works on outbuildings, while homes are better served by a full deck.
Metal Roof Installation is often paired with standing seam metal roof and metal roof replacement, depending on the cause.
Looking for Kenilworth metal roof installation? Call (908) 613-5001 to talk to a local roofer.
Call nowThe process
How metal roof installation works
Here is the usual order for a new metal roof.
Pick the panel
The roofer helps you pick the panel type, metal, gauge, finish and color, then measures every slope precisely. Many panels are made to the exact length of each slope.
Strip or cover
The old roof is torn off or, where code allows, the metal goes over one layer of shingles with battens or underlayment between. Bad decking telegraphs right through thin metal.
High-heat underlayment
A heat-rated underlayment goes down over the whole roof, plus an ice barrier in leak-prone areas. This layer is the backup if water ever gets past the metal.
Set the trim
Edge trim at the eaves and valley metal are installed before the panels. Rake trim and ridge cap come later and overlap the panels.
Run the panels
Each panel is aligned, lapped and fastened so the roof stays straight from end to end. Metal filings are swept off right away so they do not rust stain the finish.
Ridge closures
Closures, ridge cap, wall flashing and pipe boots complete the roof. Snow guards are often added above doors and walkways so snow does not slide off all at once.
What is included
Parts of a metal roof system
Underlayment
A heat-rated synthetic underlayment covers the deck as a second layer of protection.
Snow guards
Every pipe gets a metal roof boot, and snow guards go above doors for safety and a dry roof.
Panel selection
A panel system matched to the roof pitch and the look you want.
Matched trim
All trim in matching color and metal to avoid corrosion between metals.
Related service
Metal Roofing Contractor Kenilworth, NJ
Choosing a metal roofing contractor means finding someone who installs metal regularly, not occasionally. Good questions cover the panel systems they install, the underlayment they use and how they detail valleys and walls.
A metal roofing contractor in Kenilworth should talk you through panel, gauge, finish and snow guards without pushing one answer. Driving past a couple of their finished metal roofs tells you a lot about their detail work.
Related service
Stone Coated Steel Roof Kenilworth, NJ
Stone coated steel roofing looks like traditional roofing but is steel underneath a granular surface. It is lighter than tile, resists wind and hail well, and the granules soften the sound of rain.
Most stone coated steel goes on a batten system that adds ventilation beneath the panels. It suits Kenilworth homes where heavy tile would need framing upgrades.
Related service
Metal Shingle Roof Kenilworth, NJ
Metal shingles are individual interlocking panels shaped like traditional roofing units. The interlocking edges hide the fasteners, and the small size suits complex rooflines with many hips and valleys.
In Kenilworth, metal shingles appeal to homeowners who want metal performance with a traditional look. Installation details like starter, valleys and ridge are specific to each product line.
Local help
Metal Roof Installation Near Me
Around Kenilworth, metal roofing shows up on new homes, reroofs of older houses, garages and farm buildings. Across Kenilworth and nearby communities including Roselle Park, Union, Cranford and Roselle, metal roofs suit older farmhouses and new builds alike, and a roofer who installs metal regularly will know which system fits each kind of building.
Searching for metal roof installation near me from Kenilworth or Roselle Park, Union, Cranford and Roselle? Call (908) 613-5001 to talk to a roofer who works in your part of town.
What the local climate does to a roof
Winters here are long and cold, with snow on the roof for weeks at a time and plenty of nights below freezing. When warm attic air melts the snow, the meltwater runs down and freezes again at the eaves, building ice dams that push water up under the shingles. Strong coastal storms push rain into every weak spot at the flashing and valleys. Most homeowners in Kenilworth, NJ have the roof checked in the fall and again after the snow melts.
Why call
Why fix it now
Less damage
Small roof problems caught early usually stay small repairs.
Roofers who know Kenilworth
Local roofers see the same roofs and storm damage across Kenilworth and nearby towns.
Straight answers
Ask your questions before you agree to anything.
Common questions about metal roof installation
How long does a metal roof last?
A well installed steel roof commonly lasts forty years or more. Standing seam with a quality PVDF finish tends to last longest, while exposed fastener roofs need new screws along the way. Coastal exposure and dissimilar metals can shorten it.
How noisy is a metal roof?
Over a solid deck with underlayment and an insulated attic, rain on metal sounds much like rain on shingles. The loud drumming people remember comes from metal over open purlins on barns and porches. Granule-coated metal is quieter yet.
Does a metal roof attract lightning?
A metal roof does not make a strike more likely. Strikes depend on height, terrain and nearby objects, and a metal roof is no more likely to be hit than any other roof. Metal is also noncombustible, which helps if a strike does occur.
What gauge of metal roofing should I use?
Metal thickness is listed as gauge, with smaller numbers being thicker. Residential standing seam is usually 24 gauge, and ribbed panels are often 26 or 29 gauge. Ask the roofer which gauge suits your roof and local weather.
What is the difference between exposed fastener and standing seam?
The two systems attach the metal in different ways. Exposed fastener roofs show their screws and need screw maintenance, and standing seam hides its clips and lets the metal move. Many homeowners choose standing seam for houses and exposed fastener for barns and shops.
More questions? Call (908) 613-5001
Often needed together
Standing Seam Metal Roof
Standing seam metal roofs with concealed clips, raised seams and no exposed screws in the panels, for homes, additions and low slope roofs.
Learn moreMetal Roof Replacement
Full metal roof replacement, panel replacement and metal re-covers over existing roofs, chosen to fit the building and the old roof underneath.
Learn moreRoof Installation
Installing a new roof layer by layer, from drip edge and underlayment to flashing, vents and the finished roofing, so it sheds water at every edge and seam.
Learn moreCommercial Metal Roofing
Metal roof systems for commercial buildings, including new installs, replacements and leak repairs, with clips, fasteners and trim matched to the panel system.
Learn more
Looking for something else?
See all roofing servicesTalk to a Kenilworth roofer about metal roof installation
Call (908) 613-5001 to talk to a roofer serving Kenilworth, NJ.